Yea, it took a couple of months to modify the daggerboard because there really wasn’t a deadline and we worked on it only when convenient. Here’s the end of the fairing process, almost ready for primer.
and finally into Interlux Perfection paint…
Keith, I’m quite happy with the final shape:
Final step will be to measure for the standing waterline inside the dagger trunk, and paint the bottom 1.5′ or so of this board with the same bottom paint (Petit Trinidad) the hulls got in November.
Well since we can’t go sailing, we keep our eyes open for other water fun. Last week Colin led us on a hike along Yosemite Creek, originating about 8 miles north of the valley. It was pretty great to experience the creek growing with every little stream tributary feeding in.
After three hours of hiking we saw the acceleration towards the falls…
Then you get to the cliffs’ edge, and hang on tightly to the railings. We had lunch with this Raven, and I was trying to get a photo of it taking off, still working on the elusive just-right artwork of “Ravenswing” to paint on the float bows of the boat.
And over the water goes, dropping 2,400′ to the valley floor. Griffin had never seen Yosemite Valley – getting their from the top down was an amazing experience – highly recommended!
Visiting the park during waterfall season is magical. If you’re in to water. :)
Next up on Ravenswing is touch-up painting around the new starboard side port lights (windows) – recall that repair from a few months back had to be suspended because the weather at the marina has been too cold for the LPU paint to ‘kick off’ and turn glossy.
And a big hurrah! to Arlene and Glenn for sailing their Lagoon400 cat Wahoo from the Caribbean to her new home on the Chesapeake. Sounds like they had a great 1,300 mile run northbound. Hopefully they’ll let us raft up at their swanky looking dock (nice house!!!) You can check out their adventures here:
The headline would have been better if you had renamed the boat Love and War.
Looks great. Like to see how well it works with the mods.. hopefully the mast will be done soon!